![]() ![]() When electricity passes through it an electrical arc is created between the two electrodes. The starter is made up of a discharge bulb with two electrodes next to it. The filaments light up and instantly warm up the tube.When an AC voltage is applied to a tube light fixture, the voltage passes through the choke, the starter, and the filaments of the tube.This principle of the choke is exploited in lighting a fluorescent tube light. An inductor by nature always has a tendency to throw back the stored current in it, every time the power through it is switched OFF.It consists of a long copper winding over iron laminations. The choke is, in fact, a large inductor.Once the conduction of electrons between the electrodes is complete, no more heating of the filaments is required and the whole system works at a much lower current. When exposed to the ultraviolet light, the particles emit a white light which we can see. ![]() Phosphors will give off light when exposed to light. This is why the tube was coated with phosphorous. However, the light they emit is ultraviolet, and not visible to the naked eye, so another step needs to take place before we can see the light. As electrons return to their original energy level, they begin to release light. Electrons then collide with the gaseous mercury atoms, increasing the amount of energy. The energy also converts some of the mercury from a liquid to a gas.The process initially requires a relatively high amount of power. These electrode filaments are used to preheat the tube and initiate rapid conduction of electrons between the two end electrodes.The tube is then finally sealed at low pressure with two filament electrodes each at its both ends.Its inner surface is coated with phosphorous and is filled with inert gas, generally argon, with a trace of mercury. A fluorescent lamp basically consists of a long glass gas discharge tube. ![]()
0 Comments
Leave a Reply. |